Follow these easy steps to get your Zanussi 2222 047-81 Refrigerator up and running in no time.
Before using the refrigerator, remove all securing tapes. Wash the inside of the appliance with lukewarm water and a solution of bicarbonate of soda (5 ml to 0.5 litre of water). Avoid using soap or detergent to prevent lingering smells. Dry thoroughly.
Install the appliance in a location where the ambient temperature corresponds to the climate classification indicated on the rating plate. The appliance should be placed in a dry atmosphere, away from direct sunlight and extreme temperatures. It should not be installed near cookers, radiators, or boilers.
Ensure the appliance is electrically connected to a power supply with a voltage and frequency of 220-240 V / 50 Hz. The plug must be easily accessible after installation.
After installation, allow the appliance to stand for 2 hours before turning it on, to let the refrigerant settle.
Plug in the appliance and switch it on at the mains supply. Turn the thermostat control to a midway setting (3-4). Adjust the air circulation slider control, located on the back wall of the fridge section, to a midway position between 'MIN' and 'MAX'. The pilot light will illuminate.
Set the thermostat to the desired temperature between 1 (minimum coldness) and 6 (maximum coldness). Position 'G' is the 'OFF' setting.
Leave the appliance for approximately 4 hours to reach the correct temperature before placing any food inside.